AA-BOND F114 is an optically clear adhesive developed for bonding and small volume potting of plastic or glass optical fibers, lenses and prisms, LED displays and other optical components. Formulation offset to:
Hysol TRA-BOND F114
LOCTITE ECCOBOND F 114
Heat cure or Room Temperature
resistance to salt solutions, mild acids and alkalis, petroleum solvents, lubricating oils and alcohol.
Mix Ratio by weight
100:50/ Resin: Hardener
Substrates:Most metals, Ceramic, Glass and Plastics
Fiber optic assembly, Lens assembly, Prism assembly and Optical potting
Viscosity @ 25 °C, cps
1,500 (After Mixing)
@ temperature 77.0 °F, 25.0 °C
Specific Gravity, mixed
Reactive solids contents, %
Hardness, Shore D
Dielectric strength volts/mil
Volume Resistivity, ohm-cm @ 25ºC
- 60to 130°C
For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).
HOW TO USE:
1) Carefully clean and dry all surfaces to be bonded.
2) Apply AA-BOND F 114completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.
3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.
4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.
This epoxy can be supplied in various different packages.