AA-DUCT N02 is a single component, heat curing, conductive epoxy polymer that was designed for ease in handling. This high performance conductive polymer cures quickly at elevated temperatures making it ideally suited for rapid Processing and assembly.
AA-DUCT N02 passes NASA’s outgassing testing (ASTM E-595) and is listed in NASA’s Outgassing Data for Selecting Spacecraft Materials list.
AA-DUCT N02 offers excellent mechanical, electrical, and physical properties at continuous operating Temperatures up To 175°C. This versatile nickel conductive adhesive can be used for chip bonding in Micro and electronic hybrid circuit Fabrication. This unique conductive polymer also exhibits outstanding adhesion to a wide variety of substrates with good hot strength at intermittent temperatures up to 325°C.
AA-DUCT N02 has also been used in microwave applications for EMI and FRI shielding, for assembly and repair of circuit boards and Electronic component manufacturing.
microwave applications for EMI and FRI shielding, for assembly and repair of circuit boards and Electronic component manufacturing.
passes NASA’s outgassing
cures quickly at elevated temperatures
designed for ease in handling
offers excellent mechanical, electrical and physical properties
Hardness, Shore D
Volume Resistivity ohm-cm
3.8 x 10-2
@ 125 °C
@ 175 °C
Thermal Conductivity, Btu/hr/ft2/°F/in:
Operating Temp. Range, °C
-55 to +175
NASA OUTGASSING RESULTS:
TML (Total Mass Loss)
CVCM (Collected Volatile Condensable Materials)
WVR (Water Vapor Recovery)
For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).
HOW TO USE:
1) Carefully clean and dry all surfaces to be bonded.
2) Apply AA-DUCT N02 completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.
3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.
4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.
This epoxy can be supplied in various different packages.