AA-DUCT 903 Electrically Conductive, Nickel Filled Epoxy Adhesives, Room Temp Cure

$8.99 - $424.99
SKU:
AA-DUCT 903

Technical Product Bulletin

NICKEL FILLED ELECTRICALLY CONDUCTIVE EPOXY ADHESIVE


PRODUCT DESCRIPTION:

AA-DUCT 903 is an epoxy adhesive and coating formulation based on Nickel. This epoxy nickel formulation offers the maximum continuity of conductivity with an electrical resistivity value of less than 3.8x10-2 ohm-cm.

AA-DUCT 903 is recommended for electronic bonding and sealing applications that require both fine electrical and mechanical properties.

AA-DUCT 903 has been used extensively in such diversified applications as microwave EMI & RFI shielding, in the assembly or repair of printed circuit boards, wave guides, electronic modules, flat cable, high frequency shields, connections, circuitry and as a cold solder for high-sensitive components where hot-soldering is impractical.

GENERAL PROPERTIES:

Appearance Grey
Cure Type Heat cure or Room temperature
Benefits High strength
Perfect bond
Cold solder for high-sensitive components
Mix Ratio by weight 100:5 / Resin:Hardener
Substrates Excellent choice aluminum, copper, magnesium, steel, bronze, nickel, kovar, ceramic, glass, phenolic and G-10 epoxy glass boards.
Minimum Bond Line Thickness 1mm
Glass Transition Temp, Tg 50 °C
Typical Applications Electrical, conductive, rmi/efi shielding, circuitry, printed circuit board and electronics repair

UNCURED PROPERTIES:

Viscosity @ 25 °C cps Paste
Specific Gravity, mixed 2.79
Reactive solids contents, % 100
Pot Life 1 Hour
Shelf Life 1 Year

CURED PROPERTIES:

Hardness, Shore D 85
Shrinkage linear in/in 0.003
Tensile Strength, psi 9500
Volume Resistivity ohm. cm < 0.038
Compressive Strength, psi 14,000

CURE SCHEDULE:

15 minutes @ 100°C
45 minutes @ 50°C
24 hours Room temperature

THERMAL CONDUCTIVITY:

Thermal Conductivity, btu/hr/ft2/°F/in 9.4
Thermal Expansion Coefficient, (cm / cm / °C • 10-5) 1.5
Heat Distortions, °C 95
Operating Temperature Range, °C -50 to +170

GENERAL INFORMATION:

For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).

HOW TO USE:

1) Carefully clean and dry all surfaces to be bonded.

2) Apply AA-DUCT 903 completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.

3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.

4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.

AVAILABILITY:

This epoxy can be supplied in various different packages.

Data Sheets: TDS | MSDS available upon request.

Atom Adhesives
Typically replies within an hour

Atom Adhesives
Hi there 👋

How can I help you?
1:40
×
Chat with Us