AA-DUCT 902LP Silver Epoxy Adhesive, Electrically Conductive, Room Temp Curing, Air Dry, Long Pot Life

$11.99 - $7,759.99
SKU:
AA-DUCT 902LP

Technical Product Bulletin

PURE SILVER FILLED ELECTRICALLY CONDUCTIVE EPOXY, LONG POT LIFE ADHESIVE


PRODUCT DESCRIPTION:

AA-DUCT 902LP is an epoxy adhesive and coating formulation based on pure silver. This versatile silver formulation offers the maximum continuity of conductivity with an electrical resistivity value of less than 1x10-4 ohm-cm.

AA-DUCT 902LP is also characterized by a wide operating temperature range from –50 to +170°C.

AA-DUCT 902LP is recommended for electronic bonding and sealing applications that require both fine electrical and mechanical properties.

PRODUCT PROPERTIES:

Appearance Silver
Cure Type Heat cure or Room temperature
Benefits High strength
Perfect bond
Cold solder for heat-sensitive components
Mix Ratio by weight 100:6 / Resin:Hardener
Substrates Excellent choice aluminum, copper, magnesium, steel, bronze, nickel, kovar, ceramic, glass, phenolic and G-10 epoxy glass boards.
Operating Temperature –50 to +170°C
Typical Applications Electrical, conductive, rmi/efi shielding, circuitry, printed circuit board and electronics repair

UNCURED PROPERTIES:

Viscosity @ 25 °C cps Paste
Specific Gravity, mixed 2.79
Reactive solids contents, % 100
Pot Life 3 Hours
Shelf Life 1 Year

CURE SCHEDULE:

20 minutes @ 120°C
50 minutes @ 100°C
24 hours Room temperature

CURED PROPERTIES:

Hardness, Shore D 85
Shrinkage linear in/in 0.003
Tensile Strength, psi 9500
Volume Resistivity ohm. cm < 0.0001
Compressive Strength, psi 14,000
Lap Shear Strength, PSI 9400

THERMAL PROPERTIES:

Thermal Conductivity, btu / hr / ft2 / °F / in 100
Thermal Expansion Coefficient (cm / cm / °C • 10-5) 1.5
Heat Distortion, °C 95

GENERAL INFORMATION:

For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).

HOW TO USE:

1) Carefully clean and dry all surfaces to be bonded.

2) Apply AA-DUCT 902LP completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.

3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.

4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.

AVAILABILITY:

This epoxy can be supplied in various different packages.

Data Sheets: TDS | MSDS available upon request.

Atom Adhesives
Typically replies within an hour

Atom Adhesives
Hi there 👋

How can I help you?
1:40
×
Chat with Us